Cannabis Oil Vape, benefits you need to know


Cannabis oil is a concentrated form of Cannabidiol in a liquid form.  Then it is heated and inhaled through Vaporizer, Vape Pen or E-Cigarette. CBD oil is available in most places in Europe since it contains a small amount of THC (around 2%).

If you are constantly being tested at work, and you worry that you might fail this drug test and be fired, you can buy Cannabis oil vape. It is made of natural hemp plants that contain active CBD components without THC effects.cannabis oil vape pen

For those who are looking for strong effects, this might not be the best solution. Cannabis oil vape, when compared to other products that contain CBD tinctures, shows less effect. When it is being compared with smoking and vaporizing, ingesting cannabinoids has a few drawbacks, meaning there is inconsistent absorption and delayed effect.

Benefits of Cannabis Oil Vape

It is already known that marijuana has medical effects. It is used to treat diseases such as: leukemia, cancers, stress, anxiety, sleeping problems, apnea, seizures, inflammation etc. However, the effectiveness of CBD has not been officially proven and there are a lot of clinical trials that are still going on.

However, medical marijuana is mostly used to ease the pain and not as a cure. High doses are given to people who suffer from medical condition, whilst smaller doses are being used by healthy people who are looking for preventive care.

There are a lot of Cannabidiol based products on the market, such as: Pure CBD and Cannabis oil vape. Before trying any on your own, make sure you get a medical consult.

How to make Cannabis Oil Vape at home

You do not have to order Cannabis Oil Vape through the Internet. You can make your own at home and you will be good to use it.

But before you start the procedure, make sure that it goes through the decarboxylation process. This process is extremely important because raw cannabis contains high quantity of THC which is not psychoactive. Decarboxylation is the process that gives heat to the product, thus making it psychoactive.

If you are doing it for the first time, take a look at these steps for decarboxylation:

  • First heat the oven to about 115° C.
  • Break cannabis flowers and buds into small pieces. The amount for making an e-liquid should be from 30 to 35 grams.
  • Put the bud in one layer on a baking sheet.
  • Bake the leaves in the oven for about 40 minutes, and make sure that it is baked evenly.
  • The easiest way to find out if the baking is over is by looking at the color. If the final product has a brown color that means that it is done.

When this process is over, that means that you are ready to start on preparing THC e-liquid. Start by preparing all the ingredients you will need as same as the material for “cooking it”. Make sure you have the following ingredients on your table:

  • Propylene Glycol
  • 6 grams of cannabis
  • Grain alcohol (not rubbing alcohol)
  • Aluminum foil
  • One baking tray
  • Cookpot and oven

Cooking Process

When you finish with the decarboxylation you should put the cannabis leaves into a jar. In this cooking process you will have to pour grain alcohol in the jar until the material is covered.

Now pour water into a pot (approximately 4 inches) and place the jar inside. Start cooking it, and make sure you have a well ventilated space for this process. When the process is done, the product will have a nice brownish color.

After you finish with this jar, pour all the ingredients into another one and repeat this step until you have 5ml of mixture left in the jar.

Now you can add 25 ml propylene glycol in the mixture and add any flavors that you want and there you have your homemade Cannabis oil vape.


You now know what Cannabis oil vape is and how can you make it at home. In case you decide to try something else, try with Cannabidiol and Pure CBD.

Add Comment